What should I do if there is a small problem with the floor grinding machine that affects the work progress? Xingyi will help you to solve it!

1. The grinding machine suddenly stops running when it is half working

First check whether there is a problem with the power supply and connecting wires. If the power is normal, please turn off the power to check whether the motor is in good condition and whether it is burned out. If nothing happens and it cannot operate normally, it may be that the wire is too long or the power cord is too thin, resulting in insufficient voltage, just replace the wire.

2. The disc is uneven

In this case, the grinding surface will be uneven. The main reason is that the grinding disc screw has become loose. Re-lock the grinding disc screw.

3. The bearing of the grinder is damaged

The grinder is noisy, the output shaft shakes, and the gearbox shakes. It may be that the bearings of the grinder are damaged. Check the gearbox bearings in time and replace the corresponding bearings to avoid problems.

4. The grinding disc flies out of the chassis

The reason for this situation may be that the grinding disc used does not match the machine, or it may be caused by uneven construction ground and excessive speed. Please install the abrasive that matches the disk correctly, and reduce its speed to avoid this situation.

Don't worry if you encounter these problems during the construction process, you can work again after careful investigation. Xingyi is always pleased to serve you at any time.